Industrial valves, actuation and technical selection support for UK industry

British Flow Control Request a Quote

Pressure Relief Valves

Browse available pressure relief valves products and request a matched quotation.

Pressure-control equipment responds to system pressure and flow. Set point, droop, required capacity, accumulation, stability and failure behaviour must be defined for the actual system.

Where Pressure Relief Valves fit

Pressure Relief Valves may be considered where its operating principle, envelope and materials suit the process. Confirm whether the duty is isolation, throttling, diversion, non-return or pressure control; a familiar valve type is not automatically the lowest-risk choice.

Selection checklist

Factor What to confirm
Process medium Composition, concentration, solids, viscosity, toxicity and cleaning regime.
Pressure and temperature Normal, design, transient and vacuum conditions against the manufacturer curve.
Materials Body, trim, seat, seals, fasteners and coatings—not body material alone.
Connections Nominal size, bore, flange or thread standard, face-to-face and installation space.
Operation Manual or actuated, cycle rate, closing time, fail action, feedback and utilities.
Compliance Project specification, testing, water, fire-safe or hazardous-area requirements.

Common specification mistakes

  • Quoting only nominal size and pressure class.
  • Assuming a material name proves chemical compatibility.
  • Ignoring transient pressure, differential pressure or installation orientation.
  • Selecting an actuator from running torque alone.
  • Treating an approval held by one product variant as applying to the whole range.
Need a checked selection? Send the duty conditions, line standard and any available datasheet or drawing. Request a structured quotation.

Frequently asked questions

Can one pressure rating be applied to every Pressure Relief Valves?

No. The allowable pressure changes with materials, temperature, design, size and the governing standard. Use the current product pressure-temperature table.

What information is needed for automation?

At minimum: valve make and model, size, differential pressure, measured or published torque/thrust, supply, cycle time, fail action, control signal and environment.