Verified product catalogue
Choose a product
4 products match
BFC-000197
Cast Iron Globe Valve – Bellow Seal Type – Flanged PN16
Cast Iron · PN16 · PN16
Price: On Application
BFC-000275
Cast Iron Globe Valve – SDNR – Flanged PN16
Cast Iron · PN16 · PN16
Price: On Application
BFC-000483
Cast Iron Globe Valve – Angle Pattern – Flanged PN16
Cast Iron · PN16 · PN16
Price: On Application
Technical overview and selection guidance
A plug or disc moves towards a seat along a linear path. The guided movement supports throttling, but the tortuous flow path typically creates more pressure loss than a full-bore isolation valve.
Where Cast Iron Globe Valves fit
Cast Iron Globe Valves may be considered where its operating principle, envelope and materials suit the process. Confirm whether the duty is isolation, throttling, diversion, non-return or pressure control; a familiar valve type is not automatically the lowest-risk choice.
Selection checklist
| Factor | What to confirm |
|---|---|
| Process medium | Composition, concentration, solids, viscosity, toxicity and cleaning regime. |
| Pressure and temperature | Normal, design, transient and vacuum conditions against the manufacturer curve. |
| Materials | Body, trim, seat, seals, fasteners and coatings—not body material alone. |
| Connections | Nominal size, bore, flange or thread standard, face-to-face and installation space. |
| Operation | Manual or actuated, cycle rate, closing time, fail action, feedback and utilities. |
| Compliance | Project specification, testing, water, fire-safe or hazardous-area requirements. |
Common specification mistakes
- Quoting only nominal size and pressure class.
- Assuming a material name proves chemical compatibility.
- Ignoring transient pressure, differential pressure or installation orientation.
- Selecting an actuator from running torque alone.
- Treating an approval held by one product variant as applying to the whole range.
Frequently asked questions
Can one pressure rating be applied to every Cast Iron Globe Valves?
No. The allowable pressure changes with materials, temperature, design, size and the governing standard. Use the current product pressure-temperature table.
What information is needed for automation?
At minimum: valve make and model, size, differential pressure, measured or published torque/thrust, supply, cycle time, fail action, control signal and environment.